Holzstar 5902423, Инструкция по эксплуатации

Страница: 24 / 38

24 HBS Series | Version 1.02
Seetings
Fig. 56: Adjust the belt tension
Step 2: Position the motor so that the drive belt in the
middle can be pressed through approx. 10mm.
Then fix the engine again and close the lower
roller cover.
Fig. 57: Belt tension
Changing the saw blade
A saw blade change is required when using different ma
-
terials and material thicknesses, as well as worn saw
band.
Step 1: Loosen the guide rail fasteners and remove them
from the band saw.
Fig. 58: Remove guide rail
Step 2: Open the upper and lower roller cover.
Fig. 59: Open the roller cover
Step 3: Use the turning handle to set the upper saw band
roller in the lowest position and then relax saw
band.
Step 4: Remove the old saw blade.
Step 5: Insert a new saw band with the correct direction.
Step 6: Retighten the twist grip and tighten the saw blade
as described in chapter 8.3.
Fig. 60: Handle
DANGER!
Before changing the saw blade, switch off the ma
-
chine, pull out the mains plug and wait until the band
saw band stops.
Wearing safety gloves!
DANGER!
Use only suitable saw bands!
DANGER!
Make sure to insert the new saw blade correctly!
Make a note of which direction the teeth of the old saw
band are pointing!
Handle belt tension
Engine pulley
Driving belt
Belt pulley
Handle guide rail
Roller cover
Handle