HOLZMANN MASCHINEN DIPA 100, Руководство пользователя

Страница: 27 / 32

TROUBLESHOOTING
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at Seite 27
Druckluft Inverter Plasma Schneidanlage /Welder inverter plasma cutter DIPA 40 / DIPA 100
16 TROUBLESHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
TROUBLE POSSIBLE CAUSES SOLUTIONS
Power lamp not light
 No electricity input
 Power switch of machine fails
 Check incoming line
 Replace the switch
Fan not rotating
 Fan power line is off
 enclosure blocks thefan due to
deformation
 The fan fail
 reconnect the line
 reform the enclosure
 replace the fan
Warning lamp lights
 Over heat
 Over current
 Cutting after cooling
 Input voltage too low or the
machine fails
No output
 Over current protection
 The machine fails
 Over load using
 Maintenance in manufacturer
or service center
Output current decrea-
sed
 Input voltage too low
 Input line is too thin
 Reinforce power line
Current can not be
regulated
 connecting line of the
potentiometer is off
 Potentiometer of current
regulation fails
 Reconnecting the line
 Replace the potentiometer
High frequency arc can
not be generated
 The switch fails
 Incorrect selection for the air
flow, the electrode fails
 High frequency arc generator fails
 Replace the switch
 Replace the electrode
 Replace the high frequency
arc generator