holzkraft 5741400, Инструкция по эксплуатации

Страница: 19 / 26

Troubleshooting
TKS-Z 400 | Version 1.01 19
11 Troubleshooting
12 Disposal, reusing used machines
In your own interest and to protect the environment make
sure that all machine components are exclusively dis-po
-
sed of in as intended and permitted.
12.1 Decommissioning
Disused machines must be decommissioned immedi-
ately to prevent misuse at a later point and putting the
environment or persons at risk.
Step 1: Remove all environmentally hazardous fluids
from the old unit.
Step 2: If necessary, dismantle the machine into mana
-
geable and usable assemblies and compo
-
nents.
Step 3: Guide the machine components and operating
materials to the appropriate disposal routes.
12.2 Disposal of electrical equipment
Note that electrical equipment contains a variety of recy-
cling-capable materials and also environmentally hazar
-
dous components.
Please help to separate these components and dispose of
them responsibly. In case of doubt, contact your local wa
-
ste disposal authority. Consult a specialist disposal agent
for recycling if needed.
12.3 Disposing of lubricants
Lubricant manufacturers provide disposal information for
the lubricants used. If necessary, request product-spe-
cific data sheets.
Fault Possible cause Solution
Motor does not start 1.No mains voltage
2.Undervoltage relay was triggered
by a short voltage drop
3.Motor overheated, e.g. due to blunt
saw blade, excessive feed, chip ac-
cumulation in the housing
1.Have the power connection checked by qua-
lified personnel
2.Switch on again
3.Eliminate the cause of the overheating, allow
to cool for a few minutes and then switch on
again
Saw blade turns upside
down (three-phase mo-tor
only) Phases at connection reversed Swap two of three phase conductors at the
connection
Sawing power decrea-
sing Saw blade is blunt, the saw blade
may have burn marks on the sides. Replace the saw blade
Saw vibrates, saw blade
beats 1.Saw blade does not comply with
specification
2.Saw blade not sufficiently fastened
3.Saw blade is defective.
1.Check whether the saw blade is suitable for
installation using the specifications in the
technical data
2.Tighten the fixing screw
3.Check the saw blade for mechanical damage
and replace if necessary
The workpiece is knocked
back by the saw blade. 1.Fences are not correctly positioned
2.Cutting knife not aligned with the
saw blade
3.Defective saw blade
1.Adjust the fences
2.Adjust the knife with the saw blade
3.Replace the saw blade
The saw braking time is
longer than 10 seconds. Brake components worn out. Replace the motor.