holzkraft 5741400, Инструкция по эксплуатации

Страница: 13 / 26

Setting up and connecting
TKS-Z 400 | Version 1.01 13
Adjusting the saw blade inclination
The saw blade can be tilted from 90 ° to 45 ° using the
following steps.
Step 1: Loosen the locking screw (A) and tilt the saw unit
to the desired position.
Step 2: Retighten the locking screw (A)
Step 3: To precisely adjust the stop (0 ° and 90 °), loosen
the nuts (D) on the screws (B) on the frame of
the saw. Adjust the blade tilt by turning the
screws slightly.
Step 4: After successfully adjusting the saw blade incli
-
nation, retighten the lock nut.
Fig. 15: Adjusting the saw blade inclination
Replacing the saw blade
Step 1: Turn off the saw, disconnect it from the mains,
and lower the saw blade completely.
Step 2: Open the cover of the saw blade.
Fig. 16: Open the cover of the saw blade
Step 3: Loosen the lock nut with a 17 mm wrench and an
M8 hex wrench.
Fig. 17: Release the saw blade
Step 4: Remove the left nut (A) and the saw blade (C)
from the flange (B).
Step 5: Insert the new saw blade (C), install the flange
(B) and tighten the left nut (A).
Fig. 18: Installation saw blade
NOTE!
Before each adjustment make sure that the machine
has been disconnected from the mains.
Wearing safety gloves!
DANGER!
Risk of cutting the saw blade. Wear protective gloves
when mounting the saw blade.