Page | 5
Micro OSD V2
Simple Plug and Play Installation
The HolyBro Micro OSD v2 comes installed with the software installed and all of the pieces you need
so setup is very easy. All of the cables you will need to connect to the HolyBro Micro OSD v2 are
included too.
Follow the connection diagram below - connect the
Power
terminals to the battery in the model, the
TELEM port
cable into a spare telemetry port on the PixHawk flight controller and the
Camera Port
cable to the rear of the camera and the
VTx Port
cable to your VTX.
If you are using one of the HolyBro VTX Atlatl HV units then the supplied cable will plug in without
any modification. If you are using another type of video transmitter then you will have to solder the
relevant wires from the HolyBro Micro OSD V2 VTx cable to the connector/cable from the VTx you
have.
Always check that the video transmitter and camera can support the full battery voltage before you
power the system on for the first time.
If you are using a PAL camera you can solder the two PAL solder pads on the OSD.
That’s it! Power up the PixHawk and the HolyBro Micro OSD v2 and you should see the OSD in
the FPV image.
