Adjustable Bed Grab Rail
HVBARR01
Please inspect all parts
carefully for cracks/breaks
prior to use.
⚠︎
Cautions and warnings
1. Please read these instructions carefully before installing and using the bed rail.
2. This bar is not designed to support the entire weight of a person and is only suitable for people weighing less than 135 kg.
3. Narrow beds can be tilted if the body weight is fully supported by the bar.
4. The adjustable bed bar is not intended for people with reduced mobility or people who are permanently bedridden.
Additional safety measures and precautions should be used in high-risk patients.
5. The bed rail must not be attached to a medicalized bed that can move or be lifted.
6. The mattress must be tight against the grab bar without leaving any space to prevent a person from getting trapped. This
should be checked frequently, if not daily.
7. For added safety, we recommend that you install two bed rails, one on each side of the bed, to help hold the mattress in
place, without leaving any space.
Warning:
If the box spring is wider than the mattress, two bed rails will not work.
3
1. Open the carton and remove all parts. Remove the plastic coverings and dispose of safely away from children and infants.
2. The adjustable bed grab rail can be used with either two (2) crossbars or three (3) crossbars. By choosing either the two
(2) or three (3) crossbar option you can adjust the beside assist handrail height relative to the floor and to suit the user’s
preference. For thick mattresses we recommend that you use 3 crossbars. If you choose to use 2 crossbars, then part D (H-
bar) is not required. Save it for possible future use.
Assembly Instructions
3. Snap-lock part A into part B.
Repeat on other side.
6. Lastly, snap-lock part E onto either part D
or part B. Make sure that all the snap-lock
spring buttons are in place.
Tighten all
screws snugly.
*Tip
: If using part D and you experience any difficulty when you snap-lock part E
into place onto part D, slighty loosen the screws on either side of the crossbars.
Re-engage all parts with the snap-locks. Then re-tighten screws snugly.
5. If you are using part D (H-bar),
snap-lock part D onto part B.
A
A
B
B
B
C
B
D
B
B
B
D
E
B
D
B
B
E
B
E
B
4. Screw part C onto parts B using allen
key (provided). Leave screws loose.