81161
Rev 06/06/19
Page 3 of 4
www.bmracing.com
Technical Support (866) 464-6553
9.
Your
push bu
Ʃ
on switch (2)
may be installed
anywhere on shi er plate or within cab given that
its wire can reach shi er base. Choose where you
would like it to go and drill a
⁄
" hole. Install push
bu on and route wire to shi er base.
10.
Insert push bu on wiring into shi handle
connector, then plug connector into shi er base
socket. Secure wiring using clips in bo om of
shi er base compartment.
6.
Press tabs on shi er base to remove it from boot.
7.
Remove shi er collar from boot being careful not
to tear cloth material.
8.
Set
shi
Ō
handle body (1)
down onto factory shi er
stem then install screws (removed step 5) into it.
Install Magnum Grip Shi
Ō
Handle kit:
1
2
NOTE:
In this example, we installed new replacement
“TOW/HAUL” bu on into front por on of center
console, accessible but out of sight.
NOTE:
Pin posi on isn’t cri cal while wiring connector.
