NOTICE: if your grill wobbles after
putting it in place, adjust the higher of
the two feet by loosening the two nuts
and bolts retaining it and slide the foot
down until it contacts the floor, and
retightening the nuts and bolts. be sure
the narrow flanges are nearest the floor
and facing each other.
H-5
Refer to Fig. 5a
Select the following parts for assembly:
No.
Description
15
Hinges
16
Grill Lid Stop, Left
17
Grill Lid Stop, Right
18
Grill top/lid
Place the grill top squarely onto bottom.Attach
hinges to grill bottom and top with 1/4–20 bolts
and lockwashers.Attach the lid stops using the
1/4–20 bolts and lockwashers.The flanges should
point IN toward each other.
6. Refer to figure 5a
Select the two shelves (part 19) and secure to the
self brackets using the #10–24 carriage screws,
lockwashers and hex nuts.
Figure 5a
Figure 5b
7. Refer to Fig. 5b
Select the grill top handle (part 20) and secure it
to the lid using 1/4–20 bolts and lockwashers,
Insert the handle spring into the handle bracket.
Attach the stacks (part 21) to the lid using (4)
#10-24 phillips screws, lockwashers and hex nuts.
8. Install the short length of drain pipe into the
female threaded coupling in the drip pan.Tighten
with pliers or pipe wrench.
9. Open the grill top against the lid stops.
Carefully set the drip pan into the grill bottom
using the lifting tabs provided at each end.The
drip pan sets down into brackets in each end of
the body. Be sure the drain pipe extends down
through the hole in the grill bottom.
10. Install the brass drain valve by threading it
onto the end of the drain pipe extending from
the bottom of the grill. Check to be sure that the
valve is OPEN.
11. Place your 20lb. Propane tank into the notch-
es in the base bars.Attach the tank retainer to the
stand tube using the 1/4–20 wingbolt.Adjust the
retainer to secure the tank.
12. Install the regulator onto the propane tank
valve.This connection is made by the QCC-1 fit-
ting.The large plastic nut fits over the outside of
the tank valve inside will not permit the proper
amount of gas to flow.
13. Hang drip pail over the brass drain valve.
14. Check all bolts and nuts for tightness and pro-
ceed to leak testing. (Soapy water test)
18
