H-3
Figure 2
Figure 3
TOOLS NEEDED FOR
ASSEMBLY
1. 7/16” NUT DRIVER
2. 7/16”
WRENCH
3. PHILLIPS
SCREWDRIVER
4. 3/8” NUT DRIVER
The Holland Grill has been designed for easy
assembly. Most of the main grill body com-
ponents are pre-installed at the factory.The
items to be assembled are outlined at each
step below.
Model BH 421 SG-5
HERITAGE ASSEMBLY INSTRUCTIONS
BEFORE BEGINNING
PREPARE A FLAT OPEN WORK AREA SUCH AS A
GARAGE FLOOR OR PATIO. OPEN AND EMPTY
ALL BOXES AND CHECK CONTENTS TO SEE
THAT NO PARTS ARE MISSING.
Figure 1
NOTE: Hole in “Front”
1. On a flat surface (table or carport floor),
OPEN AND EMPTY BOTH BOXES. REFER TO THE
CONTENTS LIST TO BE SURE NO PARTS ARE
MISSING.
2. Refer to Figure 2. Select the following parts
for assembly:
No.
Description
1.
Stand Tube
2.
(2) Stand Tube Support
2a. Set stand tube upright with the end having 4
holes on floor and the round access hole in front.
Slide tube supports against each side of tube,
aligning four holes on each side. Start, but don’t
tighten, eight bolts and lock washers.
2b. Select left mid-brace (part 4). Place it as
shown in Figure 2. Be sure notches are up and
narrow flange is away from stand tube.
2c. Repeat for right mid-brace (part 5).
2d. Select axle brace (part 6). Place it between
left ends of stand support.Attach it to supports
with two bolts, nuts and washers at each end. Be
sure notches are up and narrow flange is toward
stand tube.AT THIS POINT,TEMPORARILY
INSERT AXLE THROUGH HOLES IN LEFT END OF
STAND SUPPORT AND AXLE BRACE.
be sure stand tube and supports are flat on the
floor and tighten all bolts securely.
2e. Install a stand foot (part 7) at the
end of each stand support having
only two holes. Be sure the nar-
row flanges are nearest the floor
and facing each other.
3. Refer to Figure 3.
Select the following parts
for assembly:
No.
Description
8
Axle
9
Push Nut (2 each)
10
Wheel (2 each)
3a. Remove axle from stand support, and install a
push nut (part 9) on one end and seat it with a
sharp hammer rap. Use a block of wood to protect
the nut.
3b. Slide a wheel (part 10) onto axle with
whitewall toward nut.
3c. Reinsert axle into stand support, slip second
wheel into place with whitewall out and install
second push nut as before.
4. Carefully remove the parts inside the grill
bottom and invert the bottom.
STAND FOOT
STAND TUBE
LIGHTER CLIP
DRIP BUCKET
DRAIN BUCKET
IGNITOR KNOB
GAS VALVE KNOB
HANDLE BRACKET
STACKS
GRILL/TOP LID
HANDLE SPRING
SHELVES
SHELF SUPPORT BRACKETS
YOUR 20LB
L.P. TANK
TANK RETAINER
HOSE REGULATOR
WHEELS
BASE BARS
