Holip HLP-A Series, Инструкция по эксплуатации

Страница: 72 / 117

HLP-A Series
HLP-A Series -
67
-
100% current is the rated current of the motor.
0: When reaching the frequency it starts to detect over-torque and when over-
torque is detected it continues to run.
1: When reaching the frequency it starts to detect over-torque and when over-
torque is detected it stop running.
2: It detects over-torque during running and when over-torque is detected it
continues to run.
3: It detects over-torque during running and when over-torque is detected it
stop running.
CD124 Over-torque Detect Mode
Set Range: 0—3 Unit: 1 Factory Setting: 0
When the output current exceeds the over-torque detection level and also
exceeds half of the set time of over-torque detection (factory setting: 1.0s), the
over-torque detection will indicate, and the corresponding multi-f unction
alarm contact will act. When it exceeds the set time, the inverter will turn to
self-protection. When this parameter is set to 0, the over-torque detection will
be invalid
CD125 Over-torque Detect Level
Set Range: 0—200% Unit: 1% Factory Setting: 0
When the inverter detects that the output current has exceeded the motor
current set value, the inverter begins to calculate the over-torque time. When
the over-torque time has exceeded half of the set detect time, the corresponding
multi-f unction output contact will act, and produce the over-torque alarm,
while the inverter will keep running. When the over-torque time has exceeded
the set detect time (set by CD126), the inverter will turn to self-protection,
display the fault information and stop output..
For the related parameters refer to CD125.
CD126 Over-torque Detect Time
Set Range: 0.1—20.0s Unit: 0.1s Factory Setting: 1.0