BA_PH_546-100_EN_06-22.docx
37
10.4
Thicknessing via Touchscreen Control
To operate the machine as a thicknesser, first turn the selector switch (
28
) to the left position (
Then proceed as described from section
11.4 onwards.
11
Touchscreen Control Unit
Figure 33: Touchscreen control unit
The touchscreen positioning control installed in the
“
Thicknesser area
”
is used for the following purposes:
•
Height adjustment of the thicknessing table
•
Calibrating the thicknessing table height
(password protected)
•
Display of the machine's operating status (emer-
gency stop, motor protection, motor voltages)
•
Display of status and error messages
•
For indicating the feed rate
(only with variable feed rate option)
•
Setting machine parameters (for authorised per-
sonnel only, see separate
Service Manual)
11.1
Buttons and Symbols
Depending on the active mode, different symbols and buttons appear on the screen of the control unit.
The respective functions are described in the following table:
Action
Function
Back to the main menu.
Starts the positioning process to the specified setpoint.
Stops a running positioning process.
Switch to incremental mode.
Switch back to absolute mode.
Starts the calibration of the table height in the setup mode.
After entering the calibration value, the
“
Set
”
button turns red. This is to indicate that
the key must now be pressed. As soon as the calibration value has been adopted, the
button changes back to the grey background.
Symbol opens the
“
Info
”
menu with relevant additional information, e.g. operating
status of the machine, such as emergency stop, motor protection and motor voltages.
If the symbol described above appears in red, an error is detected (e.g. the machine is
in the end limit zone). Work can only be continued after the error has been remedied.
Language selection in the "Info" menu (currently available: German, English and
French).
This symbol flashes when an important warning is pending and the feed of the thick-
nesser is inactive. Then tap the symbol to find out more about the error.
Start
Stop
Kette
Abs
Set
Set
i
i
