BA_PH_546-100_EN_06-22.docx
31
9
Commissioning
Read the operating manual and the chapter
“Safety”
carefully before commissioning and observe them.
Before switching on, check that
•
there are no loose parts on the thicknessing table and that all tools have been removed,
•
the guards are fitted in accordance with regulations,
•
the extraction system is connected and in working order,
•
the direction of rotation is correct,
•
the V-belts are perfectly tensioned
•
and no persons are in a danger zone of the machine
9.1
Switching the Machine ON and OFF
9.1.1
Surface Planing & Jointing
From surface planing widths > 300 mm, the table extensions must be hooked in on both
sides. Both table extensions are queried by the control. If they are not hooked in, an error
message appears (see section
11.7.1) and the machine cannot be started!
Switching ON
•
Turn selector switch (
28
) to the right position
(see
→
Button (
3
) lights up.
•
Move the planer fence the desired position.
•
Turn the main switch (
35
) to position
“
I
”
.
(see
•
Set chip removal with double push buttons.
•
Start cutter block with push button (
2
).
Switching OFF
•
Stop cutter block with push button (
2
).
•
Turn off main switch (
35
).
Figure 18: Planing & jointing controls
For further information on the operation during
“
Surface Planing & Jointing
” (
see section
9.1.2
Thicknessing
Switching ON
•
Turn the main switch (
35
) to position
“
I
”
.
•
Turn selector switch (
28
) to the left position (see
In this position the control panel for planing & jointing is deactivated.
•
Push the planing fence all the way to the front. The suction bonnet must sit on the planing fence.
The position of the planing fence is queried. Only when the fence is in the foremost
position the complete width of 630 mm can be planed.
•
Adjust the height setting to the desired value by means of the positioning control (
37
) (for procedure see
section
11.3). When pressing the
“
Start
”
button, the table moves to the required position.
•
Two step feed (standard):
Turn the selector switch (
15
) to position
I
(= 7 m/min) or to position
II
(= 14
m/min)
→
The feed runs (see section
Variable feed (option):
Turn the potentiometer (
16
) shown in section
8.3 completely to the left and
switch on the feed with the push-button (
15
). Then set the desired feed rate (3 ... 24 m/min) by turning
the potentiometer (
16
) to the right. The feed rate is visualised in the touchscreen control
4
mm
3
2