17
Doorsill
:
Fianlly, place the Doorsill on top of the Floor Profile, underneath the
door, and attach with 2 tallow-drop screws 3.5x16.
See illustration on the left.
Door Holder
:
The Door Holder - white and made out of two pieces (male and female) - is used to keep the
door open in a fixed position. Place the Holder at the top right-hand corner of the door. See
picture above. The female part has to be attached to the Curved Corner Profile and the male
part to the top profile of the Upper Door - use screws 3.5x19.Hold the parts is place, mark the
screw locations with a pen, and then drill your own holes.
Inserting the Rubber Seals
1) On the inside:
Wedge the narrower seal (3-5 mm) (as shown, pull apart if
necessary) between the Front & Back Wall Glazing Panels and the
Floor Profiles (see illustration on left). This should require little or no
strength - just push it in place with 2 or 3 fingers.
2) On the inside:
Wedge the broader/larger seal (6-8 mm) between the Roof Glazing
Panels both at the top (into the Roof Beam) and at the bottom (into
the Side Floor Profiles) (see illustration). This should require little or
no strength - just push it in place with 2 or 3 fingers.
Wedge seal to extend centrically
