10
Insert 3 Hexagon Bolts M
6 x16
Step 17: Assembly of Lateral Supports #2.0:
If you bought the optional shelving (shelving without
legs - specially designed for the RIGA greenhouses) -
refer to page 13 for further instuctions
.
If not: Lay 2 of the Lateral Supports (#2.0) on top of the Front
and Back Crossbars one on each side against the Curved
Profiles, attach to the Curved Profiles using the lowest
Hexagon Bolts you put in the Curved Profile channels, tighten
with nuts. Attach in such a manner that the L-shape goes
upwards. If you were to install their shelving later the shelf
trays will lie inside the L.
Install the second set of Lateral Supports (#2.0) about halfway
between the bottom Lateral Supports and the Roof Beam -
stay underneath the Roof Window as shown in the drawing on
page 3.
Roof Window Assembly: see Page 12
Rear Window Assembly: see Page 13
Front Door Assembly: see page 14
Mounting of a Foundation Frame:
If you have purchased the RIGA Foundation Frame (extra high 6“),
you have 2 choices about when to attach it:
(But in either case you must slide 3 Hexagon Bolts (M 6X16) into
the central channel of each Foundation Frame piece: Place one
bolt near the center and one at each end.)
Choice #1: At the beginning: Mount the Foundation Frame by
hooking it into the floor profiles #1.1 and #1.2 before you start to
assemble the RIGA greenhouse. (Many prefer this method).
Special L-brackets have been provided for you to do it this way.
You slide a Hexagon Bolt into the center channel, towards the
middle of each of the 4 Foundation Frame sections and use a L-
Bracket to hook over the Floor Profile and then over the bolts in
the Foundation Frame - hold in place with a nut. You can remove
these brackets if you wish when you have fully assembled the
greenhouse.
Choice #2. When the greenhouse frame has been completed:
You attach/hook the Foundation Frame (see picture on the left) in
single parts to the 4 Floor Profiles (remember to add 3 Hexagon
Bolts to each piece first). You will have to lift each side of the
greenhouse approx. 10-12“ above the ground. Suggestion: Place
some blocks underneath the frame to hold it up or you can lay it
on its side (yes, if you have properly assembled your greenhouse
you can lay it on its side - and this is a good test to find out!)
Either method, once the 4 Foundation Frame pieces have been
put into place you attach the 4 Corner Brackets (see picture on
the left).
A ngle Brack ets
on the Foundation Frame
Stones to lay
horiz ontally
ca
6
-
1
0
c
m
