Hog Technologies PAINT HOG, Руководство по эксплуатации

Страница: 42 / 87

42 42
Section 2 - Paint Hog Systems
Check the plunger frequently to make sure the cup
remains securely attached. If the red line begins
to show, pump the plunger to increase vacuum.
Remove the monitor and clean the suction cup
and windshield if the red line becomes exposed
frequently.
Cameras on each side of the chassis provide a
full screen image of the center road surface or
shoulder on the monitor. An adjustable cross hair
displayed on the screen is used for guidance and
alignment purposes. Typically the cross hair is
aligned to the center line, a seam or the edge of
the pavement to help maintain proper truck and
stripe carriage alignment during spray operations.
WARNING
THE VIDEO MONITOR OBSTRUCTS THE DRIVER’S FORWARD
VISIBILITY AND COULD RELEASE FROM THE WINDSHIELD
UNEXPECTEDLY WHILE TRAVELING DOWN THE HIGHWAY
I N T R AV E L M O D E . R E S T R I C T E D V I S I B I L I T Y O R A N
UNEXPECTED RELEASE OF THE MONITOR COULD RESULT
IN AN ACCIDENT. ALWAYS REMOVE AND PROPERLY STORE
THE MONITOR BEFORE SHIFTING THE TRUCK TO TRAVEL
MODE AND DRIVING ON THE HIGHWAY.
The cameras are mounted to a gimbal inside a
protective housing. The gimbal automatically com-
pensates for chassis roll to keep the camera level.
The housing is mounted on a retractable arm with
an electric actuator. Camera IN/OUT position is set
using the CAMERA EXTEND/RETRACT switches in
the cab switch panel. The camera arms are always
fully retracted for travel and extended for spray
operations.
Camera zoom and focus are manually set by re-
moving the protective lens cover on the front of
the camera housing. Once the cover is removed,
rotate the controls on the lens to set zoom and
focus. Use the monitor to verify settings. Refer
to the Operation section and the camera operation
manual for additional information on adjusting and
using the cameras.
Monitor Vacuum Cup & Pump Plunger
Typical Camera