Hofmann monty 1520, Инструкция по эксплуатации и список запасных частей

Страница: 11 / 33

11
B. Lock the rim on the turntable and rotate it to have the
valve in 5 o’clock position. Place the tire to be mounted on
the rim. Swing the mounting arm forward so that the mount/
demount tool is in the working position. Engage the lower
bead OVER the mounting wing and UNDER the mounting
finger of the mounting tool. Turn the wheel clockwise and
push the tire down into the drop center, opposite to the
mount/demount head (Fig. 4.9).
C. Mount the upper bead following the same directions in
section B (Fig.4.10).
4.2.1 If the top tire bead is difficult to mount
Follow these instructions using the optional bead clamp
(Fig. 4.10), part #EAA0247G70A.
A. After installing, the bottom bead insert the tire tool
to the left of the bead head as shown (Fig.4.11).
To protect decorative rims use protective sleeve
p/n 0024180 (optional).
B. Step on the foot pedal to rotate the turntable
clockwise until the tire lever is tight against the
bead head.
C. Using your right hand push and hold the tire bead
opposite the bead head into the rim drop centre.
D. Position the bead clamp p/n EAA0247G70A (op-
tional) to hold the tire bead into the rim drop centre
(Fig.4.10).
E. As the turntable is turning use the tire tool in your
left hand to raise and guide the tire bead onto the
bead head (Fig.4.11a).
F. Continue to rotate the turntable until the top bead
is mounted. Do not remove the tire tool or bead
clamp until the foot pedal is released.
338
4.9 4.9
4.9 4.9
4.9
339
339
4.11 4.11 4.11 4.11 4.11
4.10 4.10
4.10 4.10 4.10
339
4.11a 4.11a 4.11a 4.11a 4.11a
337
4.8 4.8
4.8 4.8
4.8