Hoffman CONCEPT CDSC24268LG, Инструкция по эксплуатации

Страница: 3 / 20

87568832 3 2005 Hoffman Enclosures Inc.
PADLOCKING HANDLE INSTALLATION
(handle provided with enclosure)
INSTALLATION STEPS
Step 1 − Remove M6 screw fastening insert to latch assembly.
Step 2 − Remove latch, insert, o − ring, and wave washer from latch housing. Apply superlube (p/n 99411823) to
handle and latch in the locations shown.
Step 3 − Assemble handle to latch housing as shown in figure 2.
Step 4 − Re − install M6 screw to handle nose and torque to 38 in − lbs (4.3 Nm).
DISCONNECT PADLOCKING HANDLE OPERATION
The disconnect padlocking handle (patent no. 5664448) provided with this enclosure incorporates an integral tool −
to − open security feature.
To gain access to the enclosure, the screwdriver slot must be turned and held 90
°
counter − clockwise.
While holding the screwdriver slot, the handle may be turned clockwise, thus opening the enclosure
door.
To close the door, push door to the closed position and turn handle counter − clockwise to latch. The
screwdriver slot will automatically reset.
Installation of a padlock will prevent the screwdriver slot from turning, therefore preventing entry to the
enclosure.
To install padlock, push button upward on bottom of handle to allow the padlock shaft to pass through
the handle as shown in figure 2.
Door
Handle
Apply
Superlube
O − Ring
Wave
Washer
Latch
M6 Screw
Apply
Superlube
When correctly assembled,
notch in rack should push
against housing flange
when latch is in closed
position.
M6 Screw
Door
Figure 2
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-16178-Hoffman-CDSC24268LG-CONCEPT-Steel-Disconnect-Enclosure.aspx