HOFFEN GS-1231, Инструкция по эксплуатации

Страница: 28 / 37

3
28
7.3 Switching the device on/off
1. To switch the device on, press the on/off/mode switch.
2. The light indicator will start flashing red.
3. Wait for a couple of seconds until it stops flashing – this means the device
is ready to be used.
4. To enable the steam burst and start ironing, press the on switch again.
5. The indicator will turn green, and the device will start emitting steam.
6. Press the on/off/mode switch again to change the operation mode to the
more powerful steam burst. The indicator will turn purple.
7. To disable the steam burst, press the on/off/mode switch for the third time.
8. CAUTION! It will not fully turn off the device. The light indicator will turn red
again – the device will remain in standby mode.
9. To fully turn off the device, press and hold the on/off/mode switch for a
longer time (approx. 2 s), until the standby LED turns off.
CAUTION!
When the water in the tank is used up, the device will not emit steam
anymore. Refill the water tank, observing all protection measures. If the
water tank is empty, the device may overheat.
Never add any cleaning agents, fragrances, scented oils or other
chemicals to the water tank. Such agents may damage the device and
render its operation dangerous.
Only use distilled or boiled water.
Always disconnect the device from the mains before starting to fill or
empty the water tank.
Do not open the water filler plug when the device is being used. The
water filler plug must always be opened slowly. Thus, any steam in
the pressurised tank will be released gradually. Observe caution – the
steam may still be hot.