54
IM_POJM180417 ARM BLOOD PRESSURE MONITORBASIC 2018-07-25
g. After the measurement, the device will switch off automatically
if idle for 1 minute. Alternatively, press the ON/OFF button to
switch off the device.
h. You may switch the device off using the ON/OFF button while
the measurement is being taken, or if you simply wish to stop
its operation.
3. Reviewing historical measurements in the device “memory
bank”
The device automatically stores the results of earlier
measurements.
a. When the device is on, press
MEM
.
b. The display will show the user identifier U1 that can be changed
to U2 by pressing the ON/OFF button. In addition, information
about measurements stored in the “memory bank” is shown
next to each user’s identifier. Press the MEM button to accept
the user. If no action is performed, the memory bank will be
accepted automatically after approx. 5 seconds (Fig. 1).
c. Then, the display will show the average value for all the results
in the current “memory bank” (Fig. 2). If no result is saved in
the current user memory zone, “0” will be displayed for blood
pressure and pulse (Fig. 3).
d. Press “MEM”, the display will show the average value of three
most recent results in the current user’s “memory bank” zone
(Fig. 4). If no result is saved in the current user’s “memory
bank” zone, “0” will be displayed for blood pressure and pulse
(Fig. 5).
e. Press “MEM” again, the memory number in the current user’s
“memory bank” zone will display (Fig. 6). If the monitor does
not save the result in the current user’s “memory bank” zone,
the display will show “0” (Fig. 7).
