Install this product in accordance with NFPA 72, the National Electrical Code, and all local codes.
WARNING!
The module must be installed by personnel familiar with electronic components. Electronic
components within the module are vulnerable to damage from electrostatic discharge. Ground straps must be worn by
installers before handling to prevent electrostatic discharge damage.
Before You Begin
Before you begin the installation, take a few minutes to review the installation information, gather the required
items, and complete the tasks listed below to make the installation as quick and easy as possible:
Acquire the following item that is not included, but may be required for installation:
l
Ground Strap
- A ground strap is required for handling circuit boards. The ground strap is not provided in
the packaging.
Placement
The Network Module provides enhanced high-speed communication for networking up to 127 fire control panels,
(addressed from 1-127). To install the network module of the FireNET L@titude Fire Alarm Control Panel:
1. Switch off AC power and disconnect the battery .
2. Connect the 40 conductor connector of the Network Module to the 40 conductor connector of the LCD
Main Processor Board as shown.
Hochiki America Corporation
FireNET L@titude Network Module (S723) Information
Guide
Version 1.05 | May 2019 | MAN-1436HA
Page 8
Installation
