Step 6
11
Step 6
10
Attaching the Tail
1. Locate the rudder and horizontal
stab assemblies and carefully remove
them from the box. It may be helpful
to watch the included video when
installing the tail section.
2. Install the rudder assembly into the
horizontal
stab, as shown.
3. Install the complete tail assembly
into the fuselage, as shown.
4. Secure this assembly to the fuselage,
from the bottom, with the included
screws. The 2 screws needed for this
step are in the small bag marked
“C” and are the two longest included.
5. Clip the tail wheel wire into the
plastic wheel housing by pulling
down slightly on the tail wheel, while
at the same time you are pushing up
on the plastic molding until the two
parts “snap” together.
6. Attach the clevis from the rudder
pushrod into the outermost hole
of the control horn on the rudder, and
slide the clear rubber sleeve down
over the clevis.
7. Attach the clevis from the elevator
pushrod into the outermost hole
of control horn on the bottom of the
elevator. Slide the clear rubber sleeve
down over the clevis. Again, refer
to the instructional video for a more
detailed
explanation.
push up
pull down
