1
0
Attention
: Check that the rudder direction matches the transmitter stick direction. Otherwise, please
reverse the rubber direction in transmitter program.
Menu items
Description
NORM
(Default)
Rotate the helicopter left (nose). Rudder servo should compensate to the right
automatically. Otherwise, change value to “REV”.
As shown in the diagram.
REV
Rotate the helicopter left (nose). Rudder servo should compensate to the right
automatically. Otherwise, change value to “NORM”. As shown in the diagram.
3
、
、
、
、
MID-TRIM---- Rudder Servo Neutral Adjustment
Attention:
Rudder SUB TRIM value of Transmitter should be set to zero . Install rudder servo horn to
closest to 90 degree. Use MID-TRIM to fine tune the neutral point of servo horn to achieve exact 90 degree.
Check the neutral position by switching the Turnigy® V-Bar 600 to the NOR mode, or by moving the rudder
stick to the left and right at least three times at high speed and immediately returning the stick to the neutral
position. This temporarily resets the rudder servo.
Menu items
Description
-100 ~ 0 ~ +100
（
Default 0
）
Fine tune rudder servo neutral point.
4
、
、
、
、
RUD-HEND----- Rudder High Travel Limit
Menu items
Description
130~ 240
(Default 160)
Adjust rudder servo travel at end limit.
Suggestion
Suggested setting between 160
～
230. If setting is higher than 230, please install ball
link to the outer hole of servo horn or use longer horns. If setting is lower than 140,
please install ball link to the inner hole of servo horn or use shorter horns. It is
recommended to keep difference between RUD-HEND and RUD-LEND within ±20.
5
、
、
、
、
RUD-LEND ----- Rudder Low Travel Limit
Menu items
Description
130 ~ 240
(Default 160)
Adjust rudder servo travel at end limit.
Suggestion
Suggested setting between 160
～
230. If setting is higher than 230, please install ball
link to the outer hole of servo horn or use longer horns. If setting is lower than 140,
please install ball link to the inner hole of servo horn or use shorter horns. It is
recommended to keep difference between RUD-HEND and RUD-LEND within ±20.
6
、
、
、
、
RUD-DEAD ------ Rudder Stick Dead Zone
Menu items
Description
5
～
100
(Default 6)
Rudder has no response if stick movement in deadband zone.Useful to prevent minor
unintentional rudder stick commands.
Suggestion
Rudder stick at neutral point.If led continue Short blink 2 times, indicating that the
Turnigy® V-Bar 600 is received rudder signal form receiver. The rudder stick is not
Direction of resulting yaw.
Direction of resulting yaw
Tail rotor
thrust
Tail rotor
thrust