1
Turnigy
®
V-Bar 600
Flybarless System V2.0
Preface
The Turnigy® V-Bar 600 is an extremely high quality precise controller and stabilizer for the swashplate and
tail rotor of a model helicopter flight control system. It has super-stabilization and super-response to control
input. This makes for incredible stability and agility. The programmability allows for performance settings
from smooth scale to sport or hard 3D flying. Flybarless also means longer flight times and a tremendous
reduction of parts and aerodynamic drag. You no longer need to use an external tail gyro, resulting in
reduced weight, with a large cost savings. The Turnigy® V-Bar 600 offers 4 switchable flight modes.
Technical details:
●
MEMS Gyro Sensors in three axes
●
Digital signal processor
●
Operating voltage: 4-10 Volts, current < 80mA
●
Temperature range: -10°C to +50°C
●
Size: 33x34x18 mm
●
Weight: 15 g
●
Servo compatibility: 1520uS/333Hz, 1520uS/250Hz, 1520uS/167Hz
and 760uS/333Hz digital servos, 1520uS/71Hz Analog servo.
●
Spare parts: foam and double-side adhesive tape and Stainless steel plate.
Installation
:
Please only use a thick double sided adhesive pad when installing the
Turnigy® V-Bar 600 to an electric helicopter. If installing on a nitro or
turbine
helicopter, you may want to use 2 double sided adhesive pads on the
bottom, plus a stainless plate on the top, plus a thin double sided
adhesive pad on the top layer for better vibration isolation.
As shown in the pictures below, When installing Turnigy® V-Bar 600 to helicopter you can choose the
following four directions. If the Turnigy® V-Bar 600 is installed on bottom of the helicopter, the same four
directions can be chosen as well.
Turnigy® V-Bar 600 runs parallel to the helicopter (nose):