E
strella
S
port
19
□
step 5
Put rudder push rod(with screw thread side) through the rudder pushrod tube hole, reach the rudder
horn position ,as picture shown.
□
step 6
Use the nylon ball joint to proofread the distance between the rudder push rod and the horn, as picture shown.
□
step7
Calculate the push rod length in need, than make a remark on the servo side, as picture shown.
□
step 8
Take out the rudder push rod and use a pliers to bend the push rod to 90°
�
as the picture shown.
□
step 9
Cut the redundant length of the push rod, as the picture shown.
7-8mm
