14
□□
step 5
Slide the wheel on the axle. Use a 5/32-inch wheel collar and a 3mm x 5mm machine screw to secure the
collar. Make sure to position the collar so the wheel can rotate freely on the axle. Use a #2 Phillips
screwdriver to tighten the screw on the flat area of the axle.
□□
step 6
Use a 1.5mm drill bit to drill two holes on the wheel pant, and then use Phillips screwdriver to drive the 2
T2*8mm self-tapping screw with washer in to the pant to retaining it.
□
step 7
Repeat steps 3 to 6 for the other side of the landing gear.
