7.
Electrical Installations
107
The van's engine must be turned off before the 230V mains
connection is hooked up.
Only plugs and cords that comply with CEE standards
may be used.
To disconnect the electric connection:
• Switch off the automatic circuit breaker
o
by pressing the
rocker switch down
n
.
• Remove the CEE feeder plug
m
(see also p. 106).
• Press the cover flap
k
(see p. 106) of the external socket
down until it clicks into place.
The 230V system is protected by a two-pole 13 A automatic
circuit breaker
o
, which is located in the seat chest in the se-
ating arrangement. It can be accessed via the side compartment.
Fuse protection for the 230V system
6
5
Automatic circuit breaker with Fi ('fast interrupt') switch
Rules for the mains connection
• Use only a 3 x 2.5 mm
2
cable with a maximum length of 25 m,
a CEE plug and connector to connect the van to an external
230 V mains.
• After the mains connection has been plugged in, both the
modular and the vehicle battery will automatically be char-
ged by the battery charger in the van (even if the Control
Panel has not been switched on).
