Hobbico Midi EDGE 540 FLWA4001, Инструкция по сборке и эксплуатации

Страница: 7 / 16

7
Be carefully and dont hurt the balsa wood below the film. Glue
the rudder with 10 min. Epoxy into the slot of body.
Glue the hinges with CA- or PVA glue into the rudder and
rudder flaps.
Look for easy movement!!
Feel out the frame for rudder servo and open the frame, using
a sharp hobby knife. Fix the servo like shown in the picture
with servo lever pointing down.
Find the correct highness of rudder lever and mark position.
Glue the elevator in absolut symmetric position in the section
of fuselage. Dont forget to put the elevator together with
the steel linkage bracket for elevator flaps into the section
of the fuselage.
Stick the hinges into the elevator using CA or PVA glue.
Afterwards glue the flaps to the linkage (epoxy) and hinges
(CA or PVA). Take care, that the flaps are not distorted!!
RUDDER ASSEMBLY
Mount the rudder rectangular to the elevator and mark with a
fine and non permanent marker along the fuselage.
Remove the covering film along this marks, using a sharp
hobby knife.
ENGLISH