Hobbico Midi EDGE 540 FLWA4001, Инструкция по сборке и эксплуатации

Страница: 6 / 16

6
ELEVATOR ASSEMBLY
For testing all matchings put all elevator parts into the section
of the fuselage.
mark along the fuselage, using a fine and non permanent
marker.
Glue the hinges into the slots in wing and aileron, using CA
or PVA glue. The glue should be very liquid for better gluing
results.
Remove this film along the marks. Be careful and do not hurt
the balsa wood below the film.
Before glueing the flap lever to the flap, renove the film
carefully from the balsa wood. Use 10 min. Epoxy glue for
mounting the levers.
Left wing, lower side Right wing, lower side
After assembly of all aileron linkages, look for the correct
center position of aileron and adjust it if necessary. If position
is ok, lock all screws, which blue locking agent.
ENGLISH