❏
2. Insert the threaded end of the elevator
pushrod into the fuselage, working it around until
the end of the rod is extending through the exit hole
on the lower left side of the fuselage.
❏
3. Install the nylon clevis onto the threaded end
of the pushrod. Turn the clevis onto the rod with
14-turns of the clevis.
❏
4. Position the rudder control horn on the
rudder. Make a mark with a felt-tip pen where the
holes need to be drilled. Note:
When installing the
control horns, the centerline of the control horn
holes must be the same as the center line of the
hinge joint as shown in the above sketch. Drill a
1/16" [1.5mm] hole through the marks you just
made. Insert the 2mm x 20mm screws through the
control horn and into the control horn backplate.
❏
5. Position the elevator control horn on the elevator
following the same procedure used for the rudder.
❏
1. Locate the plywood servo tray. Cut off the
portion of the tray indicated by the dashed line.
Radio Installation
INCORRECT
CORRECT
HINGE LINE
13
