9
❏
6. 15mm away from the back end of the cowling make two
1,5mm drillings and fi x the cowling with two 2,3x12mm wood
screws on both sides.
The best way would be, to balance the prop together with the
spinner on a suitable balancing device.
❏
7. Now you can mount propeller and spinner to the plane.
Take care, that the propeller is fi xed very good to the motor
socket.
ELEVATOR ASSEMBLY
❏
1. Insert the elevator servos so, that the servo cables are
pointing in fl ight direction. If the servos meet together in the
middle of the fuselage, take distance plates to get them free. If
you are using a S-BUS system like Futaba, dont forget to note
the servo IDs before mouting.
❏
2. Mount the elevator to the fueselage, using M3x35mm
screws. Take the covered plywood plate as base for the
backward screws.
If you like to dismount the elevator several times, it would be
better, to take a counter sink hex screw as the front screw. It is
more easy to dismount it, if rudder is installed.
❏
3. Now you can mount the boundary plates, using
M3x12mm screws with shims. Also use thread lock - blue for
this screw joint.
ENGLISH
