11
INSTALLING THE TOWING CLUTCH
❏
1. Look for the holes for towing clutch close to the sun on
the upper side of the fuselage. Cut them through and fi x the
clutch with an M3x16mm screw, using blue thread lock fl uid.
❏
2. Screw the servo into the fuselage as you can see in the
picture. Distort the 2mm steel wire so, that the movement in
the brass tube is very smooth and matches to the servo horn,
which you have used.
Adjust the servo movement so, that in closed position the
steel wire goes deep inside the opposite hole of the clutch.
In open position the steel wire should be complete out of the
clutch opening. This is necessary, that the towing rope can be
released easily.
GLUEING THE PLASTIC PANES
❏
1. Cut out the plastic panes along the molded mark
carefully. Sand the border of the panes a lttle bit and glue it to
the fuselage, using 5 min. epoxy or canopy glue.
❏
6. Screw the eye bolt into the ball links and mount them
to the rudder levers, using M2 screws with shims (Locking
agent!). Do the same at the steering lever of the tail landing
gear.
❏
7. Thread in the steering cables into the eye bolts and
bushings and crimp in the same way, like you have done
on servo side. Look for a not to strong tension of the cables.
Adjust with the thread of the eye bolts.
ENGLISH
