13
NOTE:
Registration of all-in-one headsets is the same as the beltpac registration
described below, except for step 2
If you have more than one base station, you must register each beltpac to the
base station it will be used with
REGISTER
button
REGISTRATION
STATUS window
BELTPACS
Beltpac Registration
1
Turn the base station power on, and beltpac power off
2
Plug the headset into the beltpac and put
the headset on your head
3
Press the REGISTER button on the base
station registration panel
A lower case “o” will appear on the
REGISTRATION STATUS window
4
Press and hold the ALL button on the
beltpac while you press and release its
PWR (power) button
After a brief delay, you should hear
“Registration complete” in the headset
An ID number for this beltpac will appear
briefly on the REGISTRATION STATUS window
5
Repeat steps 1 through 4 for each beltpac
NOTE:
If the registration is not successful, you will hear “Registration failed.”
If this happens, refer to Section 5. TROUBLESHOOTING, on page 21
ALL button
Power button
NOTE:
If you try to register more than 15 beltpacs to a base station:
An “F” (Full) will appear in the REGISTRATION STATUS window and you will hear
“Registration failed” in the headset
Clear all current registrations by pressing and holding the CLEAR REGISTRATION
button while you press and release the RESET button with a pen point
Continue holding the CLEAR REGISTRATION button after you release the RESET button
until the clear code “c” (lower case) appears on the REGISTRATION STATUS window
Register all beltpacs, one at a time, including previously registered beltpacs
