11
BASE switch
Right side of base station
Registration
status window
with double bar
Initialize Multiple Base Stations
Multiple base stations must be “initialized” according to the following
instructions, so their frequencies will not cause self-interference
After initializing each base station, register each beltpac that will be used
with that base station
1
On the right side of the secondary
base station, place the BASE switch
in the SEC position
2
With the primary base station
powered on first, turn on the
secondary base station
The REGISTRATION STATUS
window will show a double bar
3
Press the REGISTER button on the primary base station
The REGISTRATION STATUS window will show a small “o”
4
Press the REGISTER button on the secondary base station
to assign it a number (1, 2 or 3)
Wait until the base is initialized (approximately 10 seconds)
5
When initialization is complete, the REGISTRATION STATUS
window will show one bar
6
Press the REGISTER button on the primary base station to
clear the REGISTRATION STATUS window
The display will
also go blank after timing out
7
Repeat steps 1 – 6 to initialize up to three secondary base stations
RECOMMENDED: If only two base stations will be used, set the
secondary base station to #2
NOTE:
If you have more than one base station, you must register each beltpac to
the base station it will be used with
