Make holes
Wing Stay 1
Wing Stay 2
Wing Stay 1
(14) Install the [Wing Stay 2] to the reinforcement. (Dia. 6, 8)
(15) Remove the gauge.
(16) Make holes in the rear bumper assembly so that the [Wing
Stay 2] passes. (Dia.9)
(17) Reinstall the rear bumper assembly and the license plate.
(18) If necessary, such as when drilling has failed, attach the
[Rear Bumper Cover] to the rear bumper assembly using
M4 screws.
(19) Install the [Wing Stay 1]. (Dia.10)
Install the [Wing Stay 1] on the outside of the [Wing Stay 2].
This picture shows a typical hole’s position.
Actual position may vary depending on the vehicle.
Wing Stay 2
Bolt M8-25
Bolt M8-25
Pin
Washer M8
Washer M8
Washer M8
Washer M8
Nut M8
Nut M8
(20) Install the [Rear Wing] to [Wing Stay 1] using bolt M6-20
and washer M6. (Dia. 11)
(21) Install two
[
Wing End Plate] to the [Rear Wing] using bolt
M6-20 and washer M6. (Dia. 12)
(22) Reconnect the negative terminal to the vehicle’s battery.
Wing Stay 1
Wing End Plate
Rear Wing
14
53004-AT013_3-1.01
Dia.9
Dia.10
Dia.11
Dia.12
Содержание 53004-AT013
Страница 1: ...GT Wing 53004 AT013 TOYOTA GR Supra ...