10
53004-AT013_3-1.01
●
To prevent electrical damage/burns/fire, always:
- Disconnect the negative terminal of the battery before beginning installation.
- When disconnecting wires/connectors, take extra care to avoid breaking/snapping the connectors.
●
Do not misuse this product.
- Misuse of this product may lead to engine damage.
- Misuse of this product may lead to loss of its original function.
●
This product is made of FRP. (FRP: Fiber Reinforced Plastics)
- Deformation, damage or discoloration may occur due to excessive force, impact or high heat applied.
●
Modified parts of the painted surface need to be painted to prevent corrosion.
●
Before securing the bolts after all the painting was done, apply the screw locking agent.
●
Reinforcement of the product may be required depending on the usage conditions.
●
Always wear the safety goggles and protective mask during your work.
- Make sure that all of the parts listed in the Parts List are included in the kit.
- Reference the factory service manual for the vehicle when removing factory parts.
- Be careful when handling this product; avoid dropping or subjecting it to excessive impact. Failure to do so may result in
product damage or improper installation.
- Use the proper tools when tightening nuts and bolts. If over tightened, the bolts may become damaged.
- Keep the removed factory parts in a safe place for ease of re-installation at a later date (if necessary).
When reinstalling the removed factory parts, make sure to reinstall them correctly.
PAINTING PROCEDURE
During painting follow the below instructions to prevent the cracks or breaks.
- Temporary fit the kit parts before installation and painting to check. HKS is not responsible for any modified or painted
parts and doesn’t accept return.
- Prepare surface before painting. (clean and degrease, prime, paint etc.)
1) Using silicone remover or acetone to degrease the product surface from remaining wax or silicone.
2) Sand the surface, remove scratches by sandpaper (#240 to #400).
3) Degrease again by silicone remover or acetone and dry-wipe.
4) Prime.
5) After applying a primer, sand the surface again with sandpaper (#320 or higher)
- Check the pinholes on the surface and treat them if necessary.
- Dry at ambient temperatures. If forcibly drying, the temperature must be below 50°C/122°F.
- For other materials or tools, follow the instructions according to each manufacturer.
●
Each vehicle may have a variation in gap between body parts. Temporary fit the kit parts before installation and paint-
ing to check. HKS is not responsible for any modified or painted parts and doesn’t accept return.
Содержание 53004-AT013
Страница 1: ...GT Wing 53004 AT013 TOYOTA GR Supra ...