Hiyasu 3NHY8690, Руководство по эксплуатации

Страница: 6 / 20

En-5
Load Batteries (AAA/R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
K
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the SELECT ( / ) buttons (Fig. 5
U
) to adjust
the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
K
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
●
The Remote Controller must be pointed at signal receiver (Fig. 3 4 ) to operate correctly.
●
Operating Range: About 7 m.
●
When a signal is properly received by the indoor unit, a beeping sound will be heard.
●
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
PREPARATION
CAUTION!
● Take care to prevent infants from acciden-
tally swallowing batteries.
●
When not using the Remote Controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
● If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
● Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
● Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller's
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
Please keep the ballpoint etc. straight
and push it lightly.
Please do not push at an angle or with a
strong force.
1 Mount the Holder.
Screws
Turn on the Power
1
Turn on the circuit breaker
2 Set the Remote Controller.
Insert
3 To remove the Remote Con-
troller (when use at hand).
Slide up
9332428001_OM.indb 5 9332428001_OM.indb 5 1/7/2011 12:00:38 PM 1/7/2011 12:00:38 PM