Hitech HT884/8, Руководство пользователя

Страница: 28 / 64

Operation
22 HT800 Series VTR and Disk controller
Only the IN and OUT timecode data is stored. CUE
information does NOT include the device port active
when the CUE was created. Empty locations are
displayed as [--:--:--:--]. When the capacity of
locations is reached the message ‘End of cues’ is
displayed.
Tip: Empty locations can be used to group locations
according to use.
Deleting single cues
To delete any time code stored at any particular cue
location, press the Shift and CUE keys. Turn the
wheel to scroll through the locations. At the desired
location, press and hold the Mark IN key for more
than 1 second.
Selecting timecode source data
The TC button selects the time code source data
(hours, minutes, seconds and frames) that is
displayed on the time code display of the controller
for all connected devices.
This is selected in the following sequence: CTL, LTC,
VITC and AUTO by repeatedly pressing the TC key. If
the display shows [--:--:--:--] then no valid time
code can be read.
Note: Time code source is selected globally for all VTRs.
CTL Tape running time (hours, minutes, seconds and
frames) is computed from the recorded control (CTL)