HITEC X1 MF, Инструкция по эксплуатации

Страница: 7 / 39

05
X1 MF
SPECIAL FEATURES
Automatic Charging Current Limit
You can set the upper limit of the charging current when charging your
NiMH or NiCd batteries. This is useful for NiMH batteries of low
impedance and capacity when charging in the 'AUTO' charging mode.
Capacity Limit
The charging capacity is always calculated as the charging current
multiplied by time. If the charging capacity exceeds the limit, the process
will be terminated automatically when you set the maximum value.
Temperature Threshold
(requires optional temperature sensor, PN# 44159)
NiCd and NiMH batteries become warm as the charge process
completes. This is a normal condition and should be expected as the
Delta Peak charge process completes the charging cycle. If the user
inadvertently sets the mV sensitivity to an abnormally high value or if
there is a problem with the battery (i.e, one or more bad cells in the
pack) the battery temperature could exceed safe limits. If the external
temperature limit option is enabled and the optional temperature sensor
is installed and placed on the battery, the charge process will terminate
if the user-set temperature limit is reached. Note: Lithium and Pb
batteries should NEVER get warm during the charge process.
Processing Time Limit
Maximum charge and discharge process time limits can be set to
protect against possible battery defects.
Hitec Charge Master Software
The free “Hitec Charge Master” software gives you unparalleled ability
to operate the charger through the computer. You can monitor pack
voltage, cell voltage and other data during charging and view charge
data in real-time graphs. You can also initiate processes, control
charging and update firmware from the “Hitec Charge Master” software.