24
25
9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
Aurora Transmitter Controls
Aurora Transmitter Controls
LT, CT, RT Switches
These switches can be used as a channel control and
are used as adjustment controls for fine tuning many
of the Aurora features.
Digital Trims
The Aurora features digital trims on the face of the transmitter for throttle and the three main control functions of pitch, roll and yaw.
• A gentle pull to one side of the switch will cause the control surface to move one trim step and the radio to “beep” once.
• Hold the switch over to one side to rapidly trim a control surface.
• The size of the trim step can be adjusted in the System – TrimStep function menu.
• The graph on the screen will indicate how much movement is applied to the control surface by the trim function.
• Last trim position will be saved in memory should you switch to another model.
Stick Length Adjustment
Hands come in all sizes so to accommodate everyone we use a two piece stick “top” that can be adjusted to fit a wide variety of users.
Stick Tension Adjustment
Control Mode Changes
The Aurora offers unlimited options when customizing the gimble control functions for Mode 1, 2, 3 and 4 users. In addition the Aurora also
features two manual mode set-up menus. These are all located in the System – Mode function menu. Refer to page 63 for a detailed
explanation on how to select the mode you wish to fly.
• Easy ratchet adjustment for the throttle on each gimble.
• The radio is factory set-up for Mode 2 users in America.
• Remove the rubber pads by gently pulling up a corner and slowly pulling them off.
• Use a small Phillips head screwdriver to turn the adjustment screw clockwise to increase the spring tension, and counterclockwise to
decrease the tension of the spring.
• Fit the rubber grip pads back into place when finished.
• Separate the top from the bottom piece and adjust the top piece to the length required.
• Screw the bottom up against the top piece to “jam” lock everything into position.
M1/3
J1
J2
J3
J4
M2/4
