Hitachi WH 12DMR, Технические данные и руководство по обслуживанию

Страница: 25 / 47

--- 22 ---
8-2. Tightening Torque Inspection Prior to Operation
As described and shown in Para. 7-3-3, the output tightening torque of which the Models WH 12DMR and
WR 12DMR are capable in excess of the rated tightening torque of certain bolts and screws. Accordingly, if the
tightening time is prolonged for such bolts and screws, it could cause damage to their threads or, in the worst
case, cause them to be sheared off. (This phenomenon is common to all existing impact drivers.) Particularly
when tightening M6 (1/4") or smaller screws, tightening time must be kept extremely short: 0.5 seconds or less.
The customer should be advised to carry out several screw tightening operations and adjust the tightening time as
necessary by measuring the tightening torque with an appropriate torque wrench or driver before commencing
continuous operation.
8-3. Tightening Torque Variation
The tightening torque of the cordless impact driver or wrench may vary slightly in accordance with the factors
described below. Salespersons are requested to advise the customer to confirm that appropriate tightening
torque is obtained by measuring the torque with an appropriate torque wrench or torque driver at the beginning of
the tightening operations, and as necessary during the tightening operations. In addition, the torque values
shown in Para. 7-3-2 above are useful as a handy reference, and may be utilized as tentative standards.
(1) Voltage of battery
Tightening torque is affected by the voltage output of the battery. For example, the relationship between
tightening torque and the number of M16 x 55 mm (5/8" x 2-5/32") F10T bolts tightened is shown in Fig. 7
below. As can be seen in the graph, tightening torque decreases as the number of bolts tightened increases.
This phenomenon is caused by the decline in voltage output of the battery due to the increasing number of
bolts tightened. In particular, the tightening torque decreases rapidly just before the battery is fully discharged
(range "a" in the graph). As this phenomenon is an inherent drawback in any cordless impact driver,
salespersons are requested to ensure that the customer is fully aware of and understands this characteristic.
Model WR 12DMR
Number of bolts driven per charge (When using EB 1230HL battery)
When fully charged
M16 x 55 (5/8" x 2-5/32") F10T (Tightening time: 3 sec.)
40
80
160
0
4
12
10
20
40
60 80 100
120
T
ightening torque
Battery voltage
(pcs.)
a
400
(347 in-lbs.)
800
(694 in-lbs.)
1200
(1042 in-lbs.)
2000
(1734 in-lbs.)
200
(N.m)
When completely discharged
140
2
6
8
120
1600
(1389 in-lbs.)
(kgf.cm)
0
(V)
Fig. 7