Hitachi VT-UX717A, Руководство пользователя

Страница: 24 / 75

Getting Started (Initial Setup)
24
Getting Started (Initial Setup)
Setup for First-Time Operation
Before you use your VCR to watch or record from your TV, you need to "tell" the VCR whether
your TV uses cable or antenna input and let it program itself to receive your TV's channels. It's
also a good idea to set the clock so you can do timed recording later. With your TV and VCR
hooked up, turn them both on and follow these steps using the remote control.
Setting the Clock
This is easy to do and important for your later timed recordings.
You'll need to set the clock when first hooking up your VCR, and any time the power goes out
for more than 1 hour.
When you first plug in the VCR or after a power outage, the clock display will read "--:--".
Auto Clock Set Function
This function sets the VCR's clock automatically when the VCR is tuned to a station which
transmits a time signal together with TV programs.
It also automatically sets the time differences between various time zones and sets the time
during Daylight Saving Time (D.S.T). The auto clock set function operates each time the VCR
is turned off.
The VCR's display is lit when the auto clock set function is operating.
Some broadcast stations may not transmit a time signal. The auto clock set function does
not operate when the VCR is tuned to a station which does not transmit a time signal. In this
case, set the clock manually (see page 24).
When the clock is set automatically, the displayed time may drift from the current time by up
to one minute.
Setting the Clock with the Auto Clock Set Function
When the VCR is hooked up via an antenna or cable (no cable box):
1. Press POWER to turn the VCR power off.
When the VCR is turned off, press POWER to turn the power on, then press it again to turn the
power off.
The set time appears in the VCR display to show that the current time has been set.
It may take about five minutes for auto clock setting.
If the clock is not set after about five minutes have elapsed, press GUIDE then set the clock
manually (See page 24).
When the VCR power is recovered after a power failure of more the one hour, the clock can
be set automatically from the "--:--" indication.
If the displayed time drifts from the current time by more than one hour, select your correct
time zone and set the D.S.T. (See page 23).
When the VCR is hooked up to a cable box:
Before you begin:
Set up your cable box (See page 41).
1. Press GUIDE, then press 3 to bring up the CLOCK SET screen.