Hitachi RCD-2.0FSR, Руководство по установке и эксплуатации

Страница: 42 / 70

9.1 CONTACT DISTRIBUTOR
If the problem is not resolved even after checking the previous items or if other troubles not mentioned in the previous pages occur,
stop using the product and contact your distributor or contractor.
!
C A U T I O N
If abnormality (burnt odor, etc.) occurs, stop the operation and turn OFF the main power source immediately. If not, it may cause breakage of the
product, an electric shock or a fire. Contact your distributor or contractor.
Trouble Action before contact
The protection devices (fuse, breaker, ELB, etc) are frequently activated
or the main power source switch does not work.
Turn OFF the power source.
Water leakage from indoor unit. Stop the operation.
“Motion Sensor ON” is flashing.
There is a possibility of the failure of motion sensor. Make setting of
motion sensor invalid and contact your distributor. In that case, after the
LCD of wired remote controller display message has disappeared and
until service is finished, the operation of this unit is available.
The RUN indicator (red) is flashing.
The indoor unit number, the alarm code, the unit model code and the
connected number of indoor units are displayed on LCD.
In case that the plural indoor units are connected to one remote control
switch, the indoor unit information is indicated on LCD in number order.
So select the object indoor unit on LCD to display the information.
Check the details on LCD and contact your distributor.
Refer to the alarm code table.
Contact your distributor about the indication on the remote control
switch in detail.
Inform the following items to a distributor.
1
Unit model
2 Content of trouble
3 Alarm code number on LCD.
TROUBLESHOOTING
PMML0549 rev.1 - 02/2021 - A10761230A 10