Ð5
5Ð
Clean the air filter, as it removes dust inside the room.
Be sure to clean the filter once every two weeks so as not to consume electricity unnecessarily.
¥ To open the front panel, use the remote controller to stop unit
operation. Then press the two Ò Ó sections below PUSH at the top
left and right corners of the front panel.
¥ Grasptheleftandrightsidesofthefrontpanelandopenittowardyou.
¥ Before cleaning, stop unit operation with the remote controller and turn off the circuit breaker.
!"
#
$%" !" %"!& '%% '
¥ After using neutral detergent, wash with clean water and dry in
shade.
(
' !"
¥ Attaching the filters which are placed the surface written ÒFRONTÓ
up.
)
¥ Do not wash with hot water at more than 40¡C. The filter may shrink.
¥ When washing it, shake off moisture completely and dry it in the shade; do not expose it directly to the sun.
The filter may shrink.
¥ DonÕt operate the unit without filter. Fault may occur if you continue.
"
¥ To close the front panel, press the two Ò Ó sections below PUSH
at the top left and right corners of the front panel.
¥ Press the upper center part of the front panel to close properly.
*
¥
Do not expose the unit to water as it may cause an electric shock.
¥ For cleaning inside the air conditioner, consult your sales agent.
¥ Avoid using detergent when cleaning the heat exchanger of the indoor unit. Unit failure may result.
¥ When cleaning the heat exchanger with a vacuum cleaner, make sure to wear gloves so as not to injure your
hands on the heat exchanger fins.
!&
¥ Press the hook found at the tip of the resin band
installed inside the front panelÕs right section to
remove the resin band.
# +
¥ Be sure to use both hands to grasp the front panel when removing it or attaching it.
¥ The front panel may be installed up or down to suit user preference.
) ,
¥ Activating air conditioner drying will keep the interior of the indoor unit
dry and prevent mold formation.
¥ Turn off the circuit breaker.
¥ Pull the front panel down toward you and once
fully open, pull it to remove.
'!&
¥ Attach three front panel bearings to the axis of
the front cover. (Set the hook to face up.)
¥ Insert the tip of the resin band into the hole of the
protrusion inside the right section of the front
panel.
Air blow
Resin band
Hook
Front cover
Front panel
Resin band
(
The front panel can be washed in water. It can be kept clean at all times.
¥ Front panel can be removed and washed in water. Gently clean the
front panel using a soft sponge.
¥ When the air conditioner is to be cleaned without removing the front
panel, clean both the body and remote controller with a dry soft cloth.
¥ Wipe off water completely. If water remains on the display section or
light receiver section, this could cause a malfunction.
BENZINE
THINNER
A
C
I
D
¥ Do not splash or direct water to the body of the unit when cleaning it as this may
cause short circuit.
¥ Never clean with hot water (above 40¡C), benzine, gasoline, acid, thinner or a
brush, because it will damage the plastic surface and the coating.
