Hitachi RAC-10EX9, Руководство пользователя

Страница: 8 / 36

– 8 –
NAMES AND FUNCTIONS OF REMOTE CONTROL
ON-TIMER Button
Select the turn ON time.
OFF-TIMER Button
Select the turn OFF time.
TIME Button
Use this button to set and check the time and date.
FUNCTION Selector
Use this button to select the operating mode. Every time you
press this button, the mode will change from AUTO
→
COOL
→
DEHUMIDIFY
→
CIRCULATION
→
FAN cyclically.
FAN SPEED Selector
This determines the fan speed. Every time you press this button,
the intensity of circulation will change from AUTO
→
HI
→
MED
→
LOW cyclically.
RESET Button
Press this button after the batteries are replaced or when some
irregular operation is found.
AUTO SWING Button
Controls the angle of the horizontal air deflector.
PARALLEL WING Button
Use this button to control angle of the vertical air deflector to
parallel.
TIMER Control
Use these buttons to set the timer.
TWIN AIR FLOW Button
Use this button to allow two different air flows circulate in every
corner of room efficiently.
FILTER Button
Press this button when you have cleaned the filter. About 200
hour after this, the FILTER lamp will light to indicate that it is the
time to clean the filter.
RESERVE Button
Time setting reservation.
CANCEL Button
Cancel time reservation.
Do not put the remote controller in the following places.
Under direct sunlight.
In the vicinity of a heater.
Handle the remote controller carefully. Do not drop it on the floor, and protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch off
and on or unplug the power cord and plug it in again). This is to protect the device and does not
indicate a failure.
If you press the FUNCTION selector button during operation, the device may stop for about 3 minutes for
protection.
Precautions for Use