Hitachi PC-ALH, Инструкция по установке и эксплуатации

Страница: 10 / 30

10
PC-ALHD
1. Install the wireless receiver kit, the indoor unit and the air panel at the same time.
2. In case that the wireless receiver kit is installed after installing the indoor unit, turn off the power source of the indoor unit and
remove the air inlet grille.
3. Fix the wireless receiver kit to the air panel by screws.
(The tightening torque must be 0.8 Nm.)
Air panel
(135)
Ø7 Boss
Flange
Electrical box
for Indoor unit
Cable for wireless
Receiver kit
Screw
(Factory-Supplied)
Cable for
Auto-swing motor
Wireless Receiver kit
4. Lead the cable along the cable for the auto-swing motor and tie them by the band.
Cable for wireless Receiver kit
Band (Factory Supplied) Cable for Auto-Swing Motor
5. Remove the cover of indoor unit electrical control box and connect the cable to the terminals A and B of the terminal board.
(No polarity in terminals A and B).

NOTE:
After connecting the cable, bind up the
remaining cable length portion by band
(Factory-Supplied) and put them in the
electrical control box.
Cable for Receiver kit
Terminal Board
(White)
PCB
Mark Band (B)
Indoor unit electrical box
Mark Band (A)

INSTALLATION OF WIRELESS RECEIVER KIT
PMML0174A_r0_11-07.indb 10 22/11/2007 12:49:39