Hitachi H 25PV, Инструкция по эксплуатации

Страница: 8 / 45

4
English
STANDARD ACCESSORIES
(1) Case ............................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
䡬 Demolishing
Bull point (Square type) (Round type)
(SDS-plus shank)
䡬 Groove digging and edging
Cold chisel (SDS-plus shank)
Cutter (SDS-plus shank)
䡬 Grooving
Grooving chisel (SDS-plus shank)
䡬 Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Demolishing concrete, chipping off concrete, grooving,
bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Installing Tools
CAUTION:
Be sure to switch power OFF and disconnect the plug
from the receptacle to avoid serious trouble.
NOTE:
When using tools such as bull points, cutters, etc.,
make sure to use the genuine parts designated by
our company.
(1) Clean the shank portion of the tool.
(2) As shown in
Fig. 1 , pull grip in the direction of ,
and insert the tool into a hole of the front cap.
(3) Adjust the groove position while turning the tool,
and furthermore insert it until it hits the end of the
hole.
(4) Return grip to its original position, pull the tool and
make sure it is locked completely. ( Fig. 2 )
5. Deciding Working Position of Tool
The tool can be turned every 45 degrees and can be
fixed at the position of 8 steps.
(1) As shown in Fig. 3 , if the grip is turned in the direction
of in a state where the lock sleeve is pushed in the
direction of , the blade angle can be changed freely
to any desired position.
(2) Release lock sleeve and turn the tool, and make sure
that it is locked completely.
6. Removing Tool
As shown in Fig. 1 , pull grip, and pull out the tool.
CAUTION:
Be sure to grip the handle and cylinder case cover
portion during work. Do not hold by the grip during
work. If you pull it by mistake, the bull point could
jump out.
SPECIFICATIONS
Voltage (by areas)* (110V, 230V, 240V)
Power Input 500 W*
Full-load Impact Rate 0 – 3200 min
–1
Weight (without cord, side handle) 3.2 kg
* Be sure to check the nameplate on product as it is subject to change by areas.