Hitachi DHWT200E-2.5H1E, Инструкция по установке и эксплуатации

Страница: 16 / 188

16 PMML0198A-rev.1 - 04/2011
1 Hydraulic circuit
12 HYDRAULIC CIRCUIT
When Piping connections are performed:
1 Connect all pipes as close as possible to the unit, so that dis -
connection can be easily performed when required.
2 It is recommended to use flexible joints for the piping of water
inlet and outlet, so vibration will not be transmitted.
3 Whenever possible, sluice valves should be installed for water
piping, in order to minimise flow resistance and to maintain
sufficient water flow.
4 It is recommended to apply ball valves in both water pipe con -
nections to make easier any maintenance work.
5
Proper inspection should be performed to check for leaking
parts inside and outside the system, by completely opening
the hot water inlet and outlet valves to the water condenser.
6 This DHWT must be fully air purged to avoid heating elements
radiating the tank case without water.
7 Apply thermal insulation on the hydraulic system pipes in or -
der to avoid accidental injure due to excessive heat on piping
surfaces and also to avoid heat losses.
8 When the unit is stopped during shutdown periods and the
ambient temperature is very low, it is possible that the water
in the pipes and in the circulating pump freeze, thus dama -
ging the pipes and the water pump. In order to prevent this,
during shutdown periods it is useful to empty the water from
the installation.
N O T E
Check periodically:
• Water flow and pressure
• Water leakage’s
• Fixing points tightening
C A U T I O N
Inlet and outlet connection pipes must be 1G”
It must be kept the water flow direction indicated in previous
drawing.
DHWT(200/300)(E/S)-2.5H1E
5
2
5
5
4
7
5
5
8
1
6
H.S.W.
Recirculation
Input
Return
Mains
water input
1 Sanitary safety valve unit
2 Non-return valve
3 Circulator
4 Recirculation pump
5 Shutoff cock
6 Drain
7 Drain valve
8 Heating coil
12.1 PRESSURE DROPS
DHWT(200/300)E-2.5H1E DHWT(200/300)S-2.5H1E
0 1
0.2 0.5
10
100
20
50
200
500
5
10
2 5
C
p
=
m 3 /h
mbar
0 1
0.2 0.5
10
100
20
50
200
500
5
10
2 5
C
p
=
m 3 /h
mbar
12