--- 21 ---
(4) Removal of Guide Sleeve (C) Ass'y
[25]
(Fig. 6)
Pull out the Felt Washer
[21]
, Seal Sleeve (C)
[22]
and V-ring
[23]
from Guide Sleeve (C) Ass'y
[25]
. Pull out
Plunger (C)
[27]
from the rear of Guide Sleeve (C) Ass'y
[25]
.
Fig. 5
Fig. 6
(5) Removal of Second Shaft (D)
[47]
(Fig. 7)
Remove the two Retaining Rings for D17 Shaft
[43]
from Second Shaft (D)
[47]
. Push the end surface of
Second Shaft (D)
[47]
(parallel surface to the side of Recipro Plate (C)
[44]
) with a press supporting the side
of Recipro Plate (C)
[44]
to remove Recipro Plate (C)
[44]
in an assembly state. Push the end surface of
Second Shaft (D)
[47]
(parallel surface to the side of Recipro Plate (D)
[48]
) with a press supporting the side
of Recipro Plate (D)
[48]
to remove Recipro Plate (D)
[48]
in an assembly state. Remove the Retaining Rings
for D35 Hole
[46]
from Recipro Plate (C)
[44]
and Recipro Plate (D)
[48]
. Push off the four Ball Bearings
6003VVCM (Nylon Retainer)
[45]
from Recipro Plate (C)
[44]
and Recipro Plate (D)
[48]
. Note that the Ball
Bearings 6003VVCM (Nylon Retainer)
[45]
work as nylon retainers. Do not replace them with any other ball
bearings (6003VV).
[27]
[21]
[22]
[23]
[25]
[24]
[41]
[20]
[22]
[16]
[25]
[39]
[42]
[37]
[38]
Содержание CR 13VBY
Страница 33: ... 30 With noise suppressor type 120 V type Other type Fig 25 Fig 26 Fig 27 ...
Страница 40: ......
