10
2. Equipment connection and network setting
2.1 Required equipment preparation
2. Equipment connection and network setting
The following equipments are required to connect the projector to your PC through
the network.
■ Common
The projector: 1 unit, PC : 1 set
*1
It is recommended to install the “Live Viewer 3” into the PC.
■ Depending on how you want to connect
1) For the wired connection
*1:
For the PC, please refer to the item 3.2.1 Minimum PC hardware and software
requirement. (
23
)
*2:
An access point is required when the wireless LAN connection is used as
Infrastructure mode.
*3:
Depending on the type of wireless network device and PC you are using, the
projector may not be able to communicate properly with your PC, even if the
PC you are using is equipped with built-in wireless LAN function.
To eliminate communication problems, please use a Wi-Fi certified wireless
network device.
*4:
For more information, please consult your dealer.
LAN cable (CAT-5 or greater): 1 piece
2) For the wireless connection
*2
- Projector side
The Wireless Network Card (option : VA0833x
*4
) : 1 unit
- PC side
IEEE802.11b/g wireless LAN equipment: 1 unit
*3
2.2 Quick connection
The “Live Viewer 3” supports very quick and simple connection to the network.
It is strongly recommended to install the “Live Viewer 3” into your PC to enjoy
the feature. Proceed to the installation of the “Live Viewer 3” (
23
) and the
connection. (
26
)
In case you don’t want to use the “Live Viewer 3” or you cannot use it by some
reason, proceed to the manual setting, the item 2.3 for the wired LAN (
11
) and
the item 2.4 for the wireless LAN. (
16
)
