Hitachi C 10FSB, Технические данные и руководство по обслуживанию

Страница: 42 / 97

--- 38 ---
Disassembly procedure
Disassembly
spots
Item
No.
Necessary tools
1
Turn table, base
ass'y
1. Remove the Knob Bolt M6 x 22 [120] or the Flat Hd. Screw M6 x 25
[133] and then remove Guard (A) [121].
2. Hold the Nylon Nut M6 [35] with a 10-mm wrench and remove the
Flat Hd. Screw M6 x 25 [39] then remove Sub Fence (B) Ass'y
[38]. Remove the Machine Screw M4 x 8 [10] and then remove
the Plate [36].
3. Remove the four Bolts (W/Washers) M8 x 35 (Black) [22] and then
remove Fence (A) [53] and Fence (B) [23].
4. Loosen the Clamp Lever [3] and remove the Clutch Screw [1].
Turn the Bolt (Left Hand) M10 [4] to remove from Holder (A) [115].
5. Remove the Seal Lock Hex. Socket Set Screw M6 x 10 [119] and
tap the end of Hinge Shaft (A) [11] with a flatblade screwdriver and
a hammer to remove it from the Turn Table Ass'y [26]. This
enables to remove the head and the slide mounted on Holder (A)
[115] together from the Turn Table Ass'y [26].
6. Remove Shaft (B) [28] and remove the Turn Table Ass'y [26] from
the Base Ass'y [54A].
7. Remove the Side Handle [45] and then pull out Shaft (A) [44].
8. Remove the Machine Screw M4 x 8 [10]. Then Spring (E) [32],
Stopper (A) [31] and Pin Cover [33] can be removed from the Turn
Table Ass'y [26].
9. Remove the Seal Lock Hex. Socket Set Screw M6 x 6 [49] and pull
out the Lever Shaft [50]. Then the Lever [51] and Spring (D) [52]
can be removed. Shaft (C) [47] and Thrust Washer [48] can be
removed from the Turn Table Ass'y [26] by removing the Machine
Screw M4 x 8 [10].
10. Remove each mounting screw of Spacer (A) [43] and Table Insert
[40] to remove Spacer (A) [43] and Table Insert [40] from the Turn
Table Ass'y [26].
11. Pull out four Base Rubbers [55] from the Base Ass'y [54A].
10 mm wrench
13-mm box
wrench
Flatblade
screwdriver
17-mm box
wrench
Long-nose pliers
Phillips
screwdriver
Phillips
screwdriver
Phillips
screwdriver